Remote Control Operation Guide - McQuay MWSC 010 Series Manual

Remote Control Operation Guide

Wireless Remote Control
1. Transmission source
ó Source where the signal will be transmitted from.
2. Temperature setting
ó Set the desired room temperature
ó Press button to increase or decrease the set temperature. Setting range are between 16°C to 30°C
(Optional setting from 20°C to 30°C )
3. "ON/OFF" switch
ó Press to start the air conditioner unit.
ó Press again to stop the unit.
4. Timer setting
ó Press set button to activate the timer setting (from 1 hour to 15 hours) of the air conditioning unit. It will be in
"ON" or "OFF" condition after the set time depending to the current condition (either from "ON" to " OFF" or vise
versa).
5. Timer cancel
ó Press to cancel the timer setting.
6. Clock
ó To set the current time.
7. Automatic air swing
ó Press the button to activate the automatic air swing function. The swing angle ranging from horizontal to 25°to
bottom.
8. "Sleep" mode
ó Press the button to activate sleep mode. This mode can only be activate while in cooling mode operation. It is
activated in "COOL" mode, the set temperature will be increase 0.5°C after 30 minutes, 1°C after 1 hour and 2°C
after 2 hours.
9. Fan speed selection
ó Press the button until the desired fan speed is achieved.
10. Operation modes
ó Press the "MODE" button to select the type of operation mode.
ó Cooling unit: COOL, DRY, FAN
1
AUTO
2
3
10
4
S C
9
TIMER ON 5
FAN MODE
S C
TIMER OFF
8
SLEEP SWING 6
7
Page 45