Table of Contents
Advertisement
Changing the Password
Select a new password using the UP and DOWN buttons.
Press the FUNC button until the word "SEt" appears in
the display
See Figure
4-52. Release the FUNC button.
The number in the display is your new pass code. Make
sure you write it down! Press and hold the FUNC button
until the word "dIS" appears in the display.
NOTE
If the password is forgotten, it can be disabled by
removing the batteries. The password is intended for
rental units. It is recommended that a seal be affixed
to the rear plate of the acre counter to determine if
the settings have been tampered with.
Acre Counter
FIELD
TOTAL PULSES WIDTH P-WORD BATT
ACRES
*
Figure 4-52: Set Password
SEt
OPERATION AND MAINTENANCE
Battery Replacement
The battery operated acre counter uses 3 AA batteries.
The batteries should last between 5 and 10 years. The
acre counter will last much longer than that. Eventually,
you will have to replace the batteries. The "BATT" LED
will light when the batteries require replacement
Figure
4-53.
1. Remove the acre counter from the implement and
undo the 4 screws on the back of the case. This will
separate the housing from the rear plate.
2. Replace the batteries with 3 high quality AA alkaline
batteries.
Acre Counter
FIELD
TOTAL PULSES WIDTH P-WORD BATT
ACRES
*
Figure 4-53: Battery Replacement Required
NOTE
This unit is dust and splash resistant, under no
circumstances should this unit be submerged in any
conductive, corrosive, or flammable liquid.
10
See
4-45
Advertisement
Table of Contents
