Landoll 5110NG Operator's Manual page 37

Three-Point Hitch
The 5110NG may be equipped with a 3 point hitch versus
a pull hitch. The 3 point hitch is a standard width CAT III
hitch and will attach to any tractor with a CAT III hitch or
quick hitch.
Drills equipped with the 3 point hitch will be equipped
with drive wheels at each end of the main frame. The
drive wheels will be used to gauge the depth of the grain
drill openers when in the field. For initial adjustment, the
bottom of the 4x 4 toolbar should be approximately 20"
above the ground See Figure
ground conditions can vary this measurement. Raise or
lower the seeding depth by extending/retracting the
ratchet jack assembly on each drive wheel
Figure 4-18. Measure the pin-to-pin length of both
ratchet jacks and set them the same so the unit depth will
be even.
RATCHET
JACK
DRIVE WHEEL
ASSEMBLY (RIGHT)
3-POINT LINK
PINS & RETAINERS
4-17. Seeding depth and
See
RATCHET
JACK
DRIVE WHEEL
ASSEMBLY (LEFT)
Figure 4-18: Three-Point Hitch
OPERATION AND MAINTENANCE
Some drills will drive the seed boxes from both drive
wheels, other drills will only drive from one end. It is
important to keep the drive wheels in contact with the
ground while seeding. Failure to maintain ground contact
will result in seeding skips. Raise the drill when turning to
prevent side loading and damage to the openers and
drive wheels.
RACHET
JACK
20"
Figure 4-17: Drill Depth Adjustment
The 3 point drill should be level front-to-rear, when in the
planting position. Adjust the top 3 point link on the tractor
to level the drill front-to-rear.
4" X 4"
TOOLBAR
4-17