Table of Contents
Advertisement
PROGRAMMING
On leaving the factory, units are generally programmed with the most
common terminal and communications settings. If you need to change
these settings, custom programming can be accomplished using one of
several methods.
This manual offers programming barcodes for common functions.
Additional programming barcodes are available in the PRG, or use
software utilities which are available on the Wasp website.
Service Port Mode
To program the WPS1500 using Scanalyzer or Aladdin, the unit must
first be placed into Service Port mode, as follows:
1.
Unplug the unit if needed.
2.
While Holding down the Scan Button on the top of the unit, plug
the scanner in.
3.
The scanner will enter Service Port Mode, enabling it to be
programmed via software utilities.
Using Barcodes
It is not necessary to place the scanner into Service
Port Mode to program with barcode labels.
NOTE
After completing the physical connection between the scanner and its
host, go to the Programming Bar Codes table on the following pages to
locate the interface type for your scanner (such as RS-232, USB, etc.).
Scan a START/END bar code once to enter Programming Mode. After
scanning the programming label for the desired interface, scan the
START/END barcode a second time to accept your changes, exit
Programming Mode and return the scanner to normal operation.
10 WPS1500
Advertisement
Table of Contents
