Table of Contents
Advertisement
Center Zone Qualification
The configurable Center Zone can be set to limit the scan area to allow
Targeted Scanning of pick lists or other special items. Bar codes will read
in any orientation. The scanner will return to full pattern Presentation
Mode when set back down, after a configurable time has elapsed.
Scanner Button
The Scanner Button performs multiple functions, depending on how
long it is pressed:
Scanner Button Functions
The Scanner Button functions shown below are
operational only when the Scanner is stationary. When
in Hand/Portable mode, the button acts as a trigger to
enable the reading of a barcode label.
NOTE
PRESS
DURATION
Momentary (when
scanner is asleep)
Momentary (when
scanner is awake)
Hold, then release
when the beeper
sounds
6 WPS1500
FUNCTION
Wakes scanner from
Sleep Mode
Increments volume
Increments tone
COMMENT
Alternatively, the scanner can
be awakened by moving an
object through the scan zone.
Press the button momentarily
to increase speaker volume.
When the loudest volume is
reached, a repeated press of the
button cycles volume back to
the lowest setting, then volume
increases on subsequent
press(es). Five volume levels
are available.
Press the button for
approximately 2 seconds, then
release. Each time this is done,
the beeper will sound at one of
three tones. Stop when the
desired tone (high, medium or
low) is sounded.
Advertisement
Table of Contents
