Table of Contents
Advertisement
5. Hysteresis (
)
The hysteresis can be set.
<How to perform>
1. Keep pressing the
After [
] is indicated, press the
Then, [
] and current setting appears in turn.
2. Press the
or
Press the
button once to increase by one figure and press it continuously to keep set figure
increased.
Press the
button once to decrease by one figure and press it continuously to keep set figure
decreased.
3. Keep pressing the
Then, the setting is finished, and the measurement mode returns.
6. Output type (
)
A desired output mode can be set freely for switch output.
For the operation in normally open and normally closed,
refer to "List of output mode" on page 19.
<How to perform>
1. Keep pressing the
After [
] is indicated, press the
Then, [
] and current setting appears in turn.
2. Press the
or
3. Keep pressing the
Then, the setting is finished, and the measurement mode returns.
button for 2 seconds or longer in the measurement mode.
button four times.
button to select the hysteresis.
button for 2 seconds or longer after selection is completed.
button for 2 seconds or longer in the measurement mode.
button five times.
button to select the output type.
button for 2 seconds or longer after selection is completed.
-17-
No.PS※※-OMJ0004-E
Hide quick links:
Advertisement
Table of Contents
