5.
Deciding to perform the setting for cutting or not
CUT CONFIG
[SET]
NEXT
6.
Setting the blade force
For high-quality cutting, perform a cutting test to check the cutting quality for the media and adjust
the blade force.
When Cutting the Printed Surface
Hardened ink is thick. When cutting a printed surface, first perform a cutting test on the actual
surface that has been printed.
The end of the cap for the blade holder may scrape or damage the printed surface. If this happens,
increase the amount of blade extension.
User's Manual, "Adjusting the Cutting-in Amount" and "Adjusting for When Cutting the Printed Surface"
CUT FORCE
[SET]
NEXT
Circle
Continued on the next page
[Only Printing]
Press
Press
Go to Procedure
[Print & Cut]
Press
Press
Go to Procedure
Press
Press
The test pattern is cut. Circle and rectangle are cut. Peel off the
two shapes.
Rectangle
Setup of Media ( [MEDIA SETTING] menu )
to select [NEXT].
to enable the setting.
9
.
to select [SET].
to enable the setting.
6
.
to select [SET].
to enable the setting.
7