Roland VersaUV LEC-300 User Manual page 10

Setup of Media ( [MEDIA SETTING] menu )

CONTINUE ADJ. ?
[YES]

CUT FORCE
50gf
Current correction
value

REDO ADJ. ?
YES
For the separate setting method and descriptions for this item, see here.
Cutting Conditions"
8
[Two shapes are peeled off separately]
DONE
Press
Press
Go to Procedure
[Two shapes are peeled off together/backing paper is
also cut]
Press
Press
Go to Procedure
Press
50gf
If two shapes are peeled off together  raise the blade force.
If backing paper is cut too  reduce the blade force.
Value to be set
Press
Cut the test pattern again. Check the result.
[Two shapes are peeled off separately]
[DONE]
Press
Press
Go to Procedure
[Two shapes are peeled off together]
Press
Press
Cut the test pattern again. Go back to the procedure
again.
to select [DONE].
to enable the setting.
7
.
to select [YES].
to enable the setting.

.
to adjust the blade force.
to enable the setting.
to select [DONE].
to enable the setting.
7
.
to select [YES].
to enable the setting.
User's Manual, "Fine-tuning the


and set