Roland VersaUV LEC-300 User Manual page 11

7.
Correcting Misalignment for Printing and Cutting
Subtle misalignment between the printing and cutting positions may occur due to the thickness of
the media or the head height. We recommend making correction to match the media you're using.

PRINT-CUT ADJ.
[SET] NEXT

Check the test pattern condition.
To check the test pattern (P&C1)
Check to make sure that the printing position and the cutting position are aligned.
Cutting position and printing posi-
tion are misaligned.

CONTINUE ADJ. ?
[YES] DONE

INPUT
ADJ. VALUES
Continued on the next page
Setup of Media ( [MEDIA SETTING] menu )
Press to select [SET].
Press to enable the setting.
The test pattern (P&C1) is printed and cut. The test pattern is printed
at three locations on the media: at the two edges and in the center.
Cutting position
Printing position
Cutting position and printing posi-
tion are aligned.
[Cutting position and printing position are aligned]
Press to select [DONE].
Press to enable the setting.
8
Go to Procedure .
[Cutting position and printing position are not aligned]
Press to select [YES].
Press to enable the setting.
The test pattern (P&C2) for setting the correction values is printed
and cut. Go to Procedure
When the left figure is displayed, press

.
.
9