Roland VersaUV LEC-300 User Manual page 13

8.
Correcting Misalignment for Printing and Cutting Position When Using Crop Marks.
When you remove the printed media, and then reload it and perform cutting, use the crop marks.
For this case, correction is to be performed because the positioning of printing and cutting may be
misaligned even when you're using crop marks depending on the composition of the media.

CROP-CUT ADJ.
[SET] NEXT

Check the test pattern condition.
To check the test pattern (C&C1)
Check to make sure that the printing position and the cutting position are aligned.
Cutting position and printing posi-
tion are not aligned

CONTINUE ADJ. ?
[YES] DONE

INPUT
ADJ. VALUES
Continued on the next page
Setup of Media ( [MEDIA SETTING] menu )
[To perform consecutive printing and cutting]
Press to select [NEXT].
9
Go to Procedure .
[To perform printing and cutting separately]
Press to select [SET].
Press to enable the setting.
The test pattern (C&C1) is printed and cut. Go to Procedure
Cutting position
Printing position
Cutting position and printing posi-
tion are aligned
[Cutting position and printing position are aligned]
Press to select [DONE].
Press to enable the setting.
9
Go to Procedure .
[Cutting position and printing position are not aligned]
Press to select [YES].
Press to enable the setting.
The test pattern (C&C2) for setting the correction values is printed
and cut.
When the left figure is displayed, press

.
.
11