Roland VersaUV LEC-300 User Manual page 8

Setup of Media ( [MEDIA SETTING] menu )
4.
Performing the correction for misalignment in bidirectional printing
This machine prints by the bidirectional mode (in which the heads perform printing during both
their outbound pass and return pass). This printing method is called "Bidirectional Printing. " This
method offers the advantage of being able to shorten output times, but subtle misalignment occurs
during the outbound and return passes. The procedure to correct this and eliminate misalignment
is "Bidirectional Correction. "

ADJUST BI-DIR
[SET]

INPUT
ADJ. VALUES

ADJUST BI-DIR
0
Current correction
value
To decide a Correction Value
Choose the value that produces the least misalignment of 2lines.

REDO ADJ. ?
YES
For the separate setting method and descriptions for this item, see here.
Misalignment in Bidirectional Printing"
6
Press
NEXT
Press
The test pattern of bidirectional correction is output.
When the left figure is displayed, press
Use
-6
Press
Value to be set
The least misalignment.
Correction value scale
[To confirm again/adjust again]
[DONE]
Press
Press
The test pattern of bidirectional correction is output again. Go back
to the procedure
[To go to the next after correction is completed]
Press
Press
to select [SET].
to enable the setting.
to set the correction value.
to enable the setting.
to select [YES].
to enable the setting.

and set again.
to select [DONE].
to enable the setting.
User's Manual, "Correcting for

.
Current cor-
rection value