Roland VersaUV LEC-300 User Manual page 7

3.
Perform the position correction of feed direction (Alleviate Horizontal Stripes).
Feed direction means the feed direction of the media. Perform the correction adjusting to the media
in advance because horizontal stripes are more likely to occur during printing when the movement
distance of the media changes subtly depending on the kind or thickness of the media..

CALIBRATION
[SET] NEXT

INPUT
ADJ. VALUES

CALIBRATION
0.10% -0.10%
Current correction
value
To decide a Correction Value
Select the value to make the upper/lower rectangular gap and overlap smallest.
Gap present

REDO ADJ. ?
YES [DONE]
For the separate setting method and descriptions for this item, see here.
Correction to Alleviate Horizontal Bands and the Like"
Press
Press
The test pattern of feed correction is output.
When the left figure is displayed, press
Use
Press
Value to be set
Current correction
value
[To confirm again/To adjust again]
Press
Press
The test pattern of feed correction is output again. Go back to the
procedure
[To go to the next after correction is completed]
Press
Press
Setup of Media ( [MEDIA SETTING] menu )
to select [SET].
to enable the setting.
to set the correction value.
to enable the setting.
Smallest gap and overlap
to select [YES].
to enable the setting.

and set again.
to select [DONE].
to enable the setting.

.
Overlap
User's Manual, "Performing Feed
5