HP ProDesk 400 G7 SFF Maintenance And Service Manual page 52

WARNING!
burns if the battery is not handled properly. To reduce the risk of personal injury:
Do not attempt to recharge the battery.
Do not expose to temperatures higher than 60°C (149°F).
Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.
Replace the battery only with the HP spare part that is designated for this product.
IMPORTANT:
or replaced, the CMOS settings are cleared.
Static electricity can damage the electronic components of the computer or optional equipment. Before
beginning these procedures, be sure that you are discharged of static electricity by briefly touching a grounded
metal object.
NOTE: You can extend the lifetime of the lithium battery by plugging the computer into an AC outlet. The
lithium battery is used only when the computer is not connected to AC power.
HP encourages customers to recycle used electronic hardware, HP original print cartridges, and rechargeable
batteries. For more information about recycling programs, go to http://www.hp.com/recycle.
Before removing the battery, follow these steps:
1. Prepare the computer for disassembly
2. Remove the access panel
Remove the battery:
1. Locate the battery and battery holder on the system board.
2. Depending on the type of battery holder on the system board, complete the following instructions to
replace the battery.
44 Chapter 4 Removal and replacement procedures
The computer contains an internal lithium manganese dioxide battery. There is a risk of fire and
Before replacing the battery, back up the computer CMOS settings. When the battery is removed
(Access panel on page
(Preparation for disassembly on page
21).
21).
ENWW