Zero System Resolver - Kollmorgen EB-10X Series Installation And Service Manual

EB-10X Installation & Service Manual | Wiring
2.8.3

Zero System Resolver

To Adjust the System Resolver to zero:
Do not remove the cover while the motor is in a hazardous location.
1. Remove power.
2. Remove the motor end cover.
3. Loosen, but do not remove the resolver servo clamp screws.
4. Rotate the outer member of the resolver as needed for adjustment.
5. Replace and cover. All bolts must be tightened securely before applying power to the
motor or resolver.
18 Kollmorgen | kdn.kollmorgen.com | October 2020