Using The Quick Connector; Charging The Udi-28 - UTC UDI-28 User Manual

Using the quick connector

A quick connector is used connect the UDI-28™ unit to a power supply or to a PC.
Attach the quick connector to the UDI-28™ as show below, ensure the contacts are dry.
1. Quick Connector

Charging the UDI-28

UDI-28™ uses a rechargeable internal Li battery. This battery can be recharged only with the UDI-28™
charger.
Lithium Polymer Charging, Handling, Safety Information
NOTE: Read
WARNING: The UDI-28™ is a completely sealed unit. It may stop functioning if opened. The
warranty will be void if the unit is disassembled or the seal is broken.
Ensure that the UDI-28™ is fully charged before your dive.
Charge the battery for 12 hours prior to the first time you use the UDI-28.
To charge the UDI-28:
1. Ensure that your hands, the UDI-28™ and the charger are dry!
2. Ensure UDI-28 is "Off" and ony then connect the quick adapter to the UDI-28™
3. Connect the power charger to the quick connector.
4. Connect the power charger to a power supply. The green LED will turn on.
5. The charge is complete when the green light on the quick connector turns off.
6. If mistakenly UDI-28 is in On mode and was connected, disconnect it, power it off and then charge it.
Beacuse voltage difference between charge and operation, unit may beacome instable.
After fully charge, unit can be disconnected from the connector and turn "On".
1
2
2. Connector bracket on UDI-28
11
on page 3.