Revert To Factory Setting - UTC UDI-28 User Manual

The UDI-28™ display protective sticker may get scratched and can be replaced. The UDI-28™ can be
removed from its housing for display housing replacement as shown in the diagram below.
Remove the cover by unscrewing the tops from the two hinge screws, and pulling the hinges out of the
housing. This frees the housing and allows you to remove it from the UDI-28™ unit.
You can then pop the protective cover out, and replace it with a new cover.

Revert to factory setting

In case you need to revert to the original UDI-28 factory settings, press the Up, Down and Enter
buttons simultaneously (when the UDI-28™ is off). Wait for the UDI-28 to turn on.
All customizations and settings you have done will be erased, and UDI-28 will turn on with the original
factory settings.
30