Using The Udi-28; Turning Udi-28™ On And Off; Scrolling The Menus - UTC UDI-28 User Manual

Using the UDI-28

Turning UDI-28™ On and Off
To turn the UDI-28™ on:
1. Press and hold the Enter button for about 5 seconds. The UTC Proprietary screen opens.
(If pushing the Enter button for a short time, a message on the screen will appear mentioning
the need for a longer push)
NOTE: The UTC Proprietary screen contains a disclaimer. Clicking on the Enter button signifies that
you accept responsibility for use of the UDI-28, and that you accept the terms of the disclaimer.
If you do not agree, please do not dive with the UDI-28™.
2. Press the Enter button again. The current settings screen opens.
3. Press the Enter button again. The setup menu opens. After a few seconds, the dive info
displays.
Standby mode:
 The UDI-28™ unit goes into Standby mode after 10 minutes of inactivity on the surface.
 The UDI-28™ unit goes from Standby to 'Off' after 1 hour of inactivity on the surface.
 When in Standby mode, the UDI-28™ unit instantly returns to use upon contact with water,
or when a button is pushed for 2 seconds.
To turn UDI-28™ off:
Press and hold the Enter button for about 6 seconds. The UDI-28™ turns off.
WARNING: Power cannot be turned off during a dive.

Scrolling the menus

To scroll through the menu options, press the Up or Down buttons.
To select an option, press the Enter button.
13