Structure Of This Manual - gefran GTF Configuration And Programming Manual

STRUCTURE OF THIS MANUAL

This manual was originally written in ITALIAN. Therefore, in case of inconsistencies or doubts, request the
original manual or explanations from GEFRAN.
The instructions in this manual do not replace the safety instructions and the technical data for installation, configuration and
programming applied directly to the product or the rules of common sense and safety regulations in effect in the country of
installation.
For easier understanding of the controller's basic functions and its full potentials, the configuration and programming parameters
are grouped according to function and are described in separate chapters.
Each chapter has from 1 to 3 sections:
- the first section presents a general description of the parameters described in detail in the following zones;
- the second section presents the parameters needed for the controller's basic applications, which users and/or
installers can access clearly and easily, immediately finding the parameters necessary for quick use of the controller;
- the third section (ADVANCED SETTINGS
this section is addressed to users and/or installers who want to use the controller in special applications or in applications
requiring the high performance offered by the instrument.
Some sections may contain a functional diagram showing interaction among the parameters described;
- terms used on other pages of the manual (related or supplemental topics) are shown in underlined italics and listed
in the index (linked to IT support).
In each section, the programming parameters are shown as follows:
Main Modbus address and additional addresses (if any).
Any second / third Modbus addresses are alternatives to the main address.
Mnemonic code (if any)
400
tYP.
21 - 29 - 143
Function
68
STATE
DIGITAL INPUT 1
bit
80961F_MSW_GTF/GTF-Xtra_07-2018_ENG
R read only (read) and/or W (write) attribute
Description
R/W
Type of probe, signal, enable, custom
linearization and main scale input
Supplemental data and/or
information
OFF = Digital input 1 off
R/W
OFF = Digital input 1 on
) presents parameters for advanced use of the controller:
Supplemental data and/or information on the parameter
Setting limits
-999...999 Supplemental data and/or information
Scale points dP_S
0
1
2 xx.xx (*)
Supplemental data and/or
information
Unless indicated otherwise,
these parameters are in
decimal format and
represent 16 bit words.
0 ...1
These parameters are represented in 1 bit format.
Default value
Format
xxxx
xxx.x
1000
0
5