Stop Modes; Normal Stopping; General Stop - GIRBAU ED260 Operation And Maintenance Instruction Manual

Standby mode at end of program
On completing the drying program and corresponding cooling-down phase, and while the door remains
unopened, the machine will remain in standby mode.
During standby mode, provided that the internal temperature is high, the dryer will rotate the drum and run the
fan intermittently.

4.6. Stop modes

4.6.1. Normal stopping

Pressing the key
Pressing the button halts the heating system and the program.
The following icon is displayed on screen, requesting confirmation of the Stop command.
If after a few seconds the door is still closed and neither of the two options is selected, the program will
continue.
Opening the door while the STOP icon is displayed will end the program.
Opening the door during the drying stage:
The rotation and heating will stop.
On re-closing, the program will continue.
Opening the door will not stop the program time.

4.6.2. General Stop

Models ED460 and ED660 only.
Disconnecting the mechanically lockable breaker switch, located at the rear of the machine. COMPLETELY
disconnects the machine from the power supply. Suitable for maintenance procedures and when the machine is
idle for long periods.
Mechanically locking breaker switch
Set the breaker switch at the " 0" position.
Fit a padlock on the bottom opening to prevent the breaker switch being handled by others.
Program execution mode
Ending the program
The program will end definitively.
While the dryer's internal temperature is high,
the suction fan will continue to run.
Cancelling the STOP command
The program will continue from the point where it
was interrupted.
18
Code no. 576017
Rev. nº 02/0415