Troubleshooting; Troubleshooting Operation Problems - GIRBAU ED260 Operation And Maintenance Instruction Manual

10. TROUBLESHOOTING

10.1. Troubleshooting operation problems

PROBLEM
DRIED LINEN MOISTURE
LEVEL TOO HIGH
INCORRECT DRUM
SPEED
FLAME TOO ORANGE
(GAS VERSION)
THE BURNER CAN NOT
BE IGNITED (GAS
VERSION)
POOR FLAME SPREAD
(GAS VERSION)
PROBLEMS COUNTING
COINS OR TOKENS
PROBABLE CAUSE
Excessive residual moisture in the
fabrics being dried
Insufficient drying time
Temperature too low
Inverter breakdown
Fault in the drum rotation detector
Faulty air intake filter
Poor air/gas mixture
Manual gas flow valve closed
Insufficient supply of gas
Gas ignition system defective or
ignition electrodes misplaced
Insufficient supply of gas
Blocked burner holes
Error in configuring parameters related
to the coin meter box or token counter.
Poorly adjusted or faulty counting
devices.
Alarms
Adjust the spin process.
Alter the program to increase the
drying time.
Alter the program to increase the
temperature.
Call the
Services.
Call the
Services.
Clean the filter.
Check, and if necessary correct,
the position of the venturi.
If the problem persists, contact the
Authorised Technical Services.
Open the manual gas flow valve.
Ask a
contractor to check the gas supply
pressure and flow rate.
If the problem persists, contact the
Authorised Technical Services.
Call the
Services.
Ask a
contractor to check the gas supply
pressure and flow rate.
If the problem persists, contact the
Authorised Technical Services.
Call the
Services.
Error in configuring parameters
related to the payment system.
If the problem persists, contact the
Authorised Technical Services.
Call the
Services.
ACTION
Authorised Technical
Authorised Technical
registered installation
Authorised Technical
registered installation
Authorised Technical
Authorised Technical
Code no. 576017
Rev. nº 02/0415
36