Explanation Of Terminology For The Half Cylinder - Assa Abloy Aperio C100 V3 Installation And Mounting Instructions

Term
Knob
I
(electronic side,
outside)
1 Cylinder knob cover
2 Special tool
(optional)
3 CR2 battery
4 Bolt washer
Guide
5
6 Securing sleeve
7 Cylinder fixing screw The knob cylinder is fixed in the mortise lock by the cylinder fixing screw.
8 Cylinder housing
9 Knob mount
10 Battery
compartment
11 USB interface
36 EN
Approved 2017-08-16

Explanation of terminology for the half cylinder

Description
Knob on the electronic side consisting of:
· cylinder knob cover (
· battery compartment (
· knob mount (
The cylinder knob cover is a cover for the knob cylinder C100 V3.
The knobs can be removed using special tool.
The CR2 battery supplies power to the electronic knob cylinder C100 V3.
The bolt washer is screwed into the respective side with the knob holder.
It has a flat area and a point-shaped marking that must point in the
direction of the cylinder housing on both sides.
The guide on the locking disc guarantees that the knob is mounted
correctly.
The securing sleeve is fitted on the part of the knob spindle protruding
from the cylinder housing. It accommodates the connecting cable (flex-
ible connector) on the cylinder housing (
The cylinder housing is installed in the door with the cylinder fixing screw
6
( ). The connecting cable (flexible connector) to the battery compart-
9
ment ( ) is exposed when you remove the knob.
The knob on each side is inserted in the knob mount and screwed
together with the bolt washer (
to fit the parts together, which is determined by the position of the bolt
washer.
The battery compartment is screwed into the knob spindle with the knob
8
mount ( ). A CR2 3 V battery (
The USB interface is used for setting up the cylinder with the PAP tool
(software for configuring door systems) and for firmware updates.
1
),
9
) for CR2 battery (
8
).
6
). In the process, there is only one way
3
) must be inserted.
3
) and
7
).
Notices