Assa Abloy Aperio C100 V3 Installation And Mounting Instructions page 37

Term
12 Tamper protection
contact (tampering)
13 Turning aid
(optional)
Pic. 3 :
Schematic view of
the electronic
knob cylinder
C100 V3,
half-cylinder with
removable knob
version
Functions and operation
Approved 2017-08-16
Description
With the tamper protection contact (tampering) activated, a signal can be
sent to the primary control unit if the knob on the electronics side has
been removed (e.g. when replacing the battery or during a tampering
attempt). An alarm is also saved in the internal memory and the motor
is run in decoupled state. This alarm is indicated by the red flashing LED
(„Monitoring via tamper protection contact (tampering)", Seite 39).
The turning aid is fit over the knob after installation. It makes it easier to
turn the knob and can be purchased as an accessory.
I
4
2 3
1
10
11
13
12
5
6
8
9
7
EN 37