Using The J-Web Interface; Using The Cli - Juniper SRX Series Manual

SRX Series Services Gateways for the Branch Physical Interface Modules Reference

Using the J-Web Interface

Using the CLI

210
To perform basic configuration for the 1-Port ADSL2 Mini-PIM and to configure network
interfaces for the services gateway using the J-Web interface:
In the J-Web interface, select
1.
The Interfaces page displays and lists the network interfaces present on the services
gateway, along with configuration information (if configured).
To configure properties for a network interface (Mini-PIM), select the interface name
2.
( for example at-1/0/0 ), and click
To use the port on the Mini-PIM, you must assign it to a security zone other than the
3.
Null zone. Optionally, you can also assign the port an IP address (for example,
192.168.3.1/24). Enter or select the following settings:
Select Configure>Security>Zones
a.
Add or select a security zone other than Null; for example,
b.
For host inbound traffic, set the following:
c.
System Services=
Protocols=
Allow All
Click to save changes, and click
d. OK
pending changes.
To use the port on the Mini-PIM, you must also set security policies. Select the following
4.
settings:
Select
a. Configure>Security>Policy>Apply Policy
Set Policy Action: Default Policy Action=
b.
Click to save changes, and click
c. OK
pending changes (if any).
See the Junos OS Network Interfaces Configuration Guide
To perform basic configuration for the 1-Port ADSL2+ Mini-PIM and to configure network
interfaces for the services gateway with the CLI:
Verify that the serial interface is installed on the device:
show chassis hardware
Verify the status of the interface:
show interfaces terse
Assign the port an IP address:
Configure>Interfaces>Ports
Edit .
.
Allow All
to apply the configuration and other
Commit
Permit-All
to apply the configuration and other
Commit
.
.
Trust
.
.
for more details.
Copyright © 2015, Juniper Networks, Inc.