Web User Interface Conventions; Command Line Interface Conventions - Juniper SSG 500M Series Hardware Installation And Configuration Manual

Hide thumbs Also See for SSG 500M Series:
Table of Contents

Advertisement

SSG 500M-series Installation and Configuration Guide

Web User Interface Conventions

Command Line Interface Conventions

NOTE:
6
Organization
The Web user interface (WebUI) contains a navigational path and configuration
settings. To enter configuration settings, begin by clicking a menu item in the
navigation tree on the left side of the screen. As you proceed, your navigation path
appears at the top of the screen, with each page separated by angle brackets.
The following example shows the WebUI path and parameters for defining an
address:
Policy > Policy Elements > Addresses > List > New: Enter the following, then
click OK:
Address Name: addr_1
IP Address/Domain Name:
IP/Netmask: (select), 10.2.2.5/32
Zone: Untrust
To open online Help for configuration settings, click the question mark (?) in the
upper left of the screen.
The navigation tree also provides a Help > Config Guide configuration page to help
you configure security policies and Internet Protocol Security (IPSec). Select an
option from the list and follow the instructions on the page. Click the
the upper left for Online Help on the Config Guide.
The following conventions are used to present the syntax of command line
interface (CLI) commands in text and examples.
In text, commands are in boldface type and variables are in italic type.
In examples:
Variables are in italic type.
Anything inside square brackets [ ] is optional.
Anything inside braces { } is required.
If there is more than one choice, each choice is separated by a pipe ( | ). For
example, the following command means "set the management options for the
ethernet1, the ethernet2, or the ethernet3 interface":
set interface { ethernet1 | ethernet2 | ethernet3 } manage
When entering a keyword, you only have to type enough letters to identify the
word uniquely. For example, typing set adm u ang j12fmt54 is enough to enter
the command set admin user angel j12fmt54. Although you can use this shortcut
when entering commands, all the commands documented here are presented in
their entirety.
?
character in

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ssg 520mSsg 550m

Table of Contents