Table of Contents
Advertisement
Settings and Measurement
(8) Interface settings
This menu is used to specify conditions for PC connection.
Interface
USB Settings
TCP/IP Settings
(8)-1 Interface
This section allows you to set the new line code to use when controlling the PC connection with the
interface commands.
New Line Code
(8)-2 USB Settings
Sets the USB ID number of MT100.
Specify a number from 0 to 9.
When multiple devices are controlled from a single PC, make sure each device is assigned to a different
ID number.
CAUTION
You must restart MT100 after any change is made to a setting value.
Changes are applied upon restart.
(8)-3 TCP/IP Settings
Sets values to establish an Ethernet connection.
IP Address
Subnet Mask
Port Number
Gateway
DNS Address
CAUTION
You must restart MT100 after any change is made to a setting value.
Changes are applied upon restart.
3-38
Items
Settings 1
New Line Code
USB ID
IP Address
Subnet Mask
Port Number
Gateway
DNS Address
Setting items
CR+LF
LF
CR
Setting items
Sets the IP address of MT100 (0 to 255 . 0 to 255 . 0 to 255 . 0 to 255).
Sets the IP subnet mask of MT100 (0 to 255 . 0 to 255 . 0 to 255 . 0 to 255).
Sets the port number of MT100 (1024 to 65535).
Sets the gateway of MT100 (0 to 255 . 0 to 255 . 0 to 255 . 0 to 255).
Sets the DNS address of MT100 (0 to 255 . 0 to 255 . 0 to 255 . 0 to 255).
Settings 2
CR+LF, LF, CR
0 to 9
0 to 255 . 0 to 255 . 0 to 255 . 0 to 255
0 to 255 . 0 to 255 . 0 to 255 . 0 to 255
1024 to 65535
0 to 255 . 0 to 255 . 0 to 255 . 0 to 255
0 to 255 . 0 to 255 . 0 to 255 . 0 to 255
Description
Starts a newline with CR+LF code.
Starts a new line with LF code.
Starts a new line with CR code.
Description
Selections available
Advertisement
Table of Contents
