Table of Contents
Advertisement
Settings and Measurement
(2)-1 Record Settings
This section allows you to set conditions for data capture.
(1)
Sampling
(2)
File Name
(3)
Name Type
(4)
File Type
CHECKPOINT
• To use the digital filter function, you must set the AC power supply frequency accurately.
Follow the instructions on page 3-39 to ensure that the settings are accurate.
CAUTION
• If you perform data capture with Name File set to Auto, data will be saved in a folder automatically
created with the date as its name.
• If you perform data capture repeatedly with Name File set to Auto, the amount of time taken to begin
measurement will increase as the number of files increases.
In such a case, create a new folder as an alternative destination.
• When you save files, create a folder and then save the files in the folder.
Regardless of the remaining capacity, if you try to save files in the root directory, due to file restrictions
you may not be able to save files.
• The displayed Capture Time may vary according to the sampling interval or number of capture channels.
3-22
①
②
②
③
④
Setting items
Sets the interval for data capture.
100, 125, 200, 250, 500 ms, 1, 2, 5, 10, 20, 30 s, 1, 2, 5, 10, 20, 30 min, 1 h
*Digital filter (50/60 Hz) will be enabled when sampling interval is 500 ms or above.
Sets conditions of data files.
*Specify folder/file names according to need.
MEM
USB1
Sets how the file is named.
Auto
User
SN
Sets the format of the data file.
GBD
CSV
Description
Captures data into the internal Flash memory.
Captures data into the USB memory connected to the USB memory slot.
File name is specified automatically.
ex) 20050101-123456_UG.GBD
numerals ---date and time created
*The above example is for January 1, 2005 at 12:34:56.
UG
-------- number of user capturing data
UG (Guest)
U1 (User 1)
U2 (User 2)
GBD -------- data format
GBD (Binary data)
CSV (text format)
Captures data using a user-defined file name.
Creates a file by appending a serial number to the user-defined file name.
ex) if file name is "TEST",
first file
: TEST_SER1.GBD
second file : TEST_SER2.GBD
third file
: TEST_SER3.GBD
Creates data files in a proprietary binary format.
*Data cannot be altered.
Creates data files in text format.
*Cannot be replayed in MT100.
Advertisement
Table of Contents
