Table of Contents
Advertisement
Checks and Preparation
(1) Remove the masking tape from the surface where the brackets should be attached.
(2) Insert the device from the front side of the panel.
(3) Mount the device to the panel using the provided brackets, as shown in the figure below.
i.
Brackets must be attached on two surfaces: top and bottom OR left and right surfaces
(make sure you have removed the masking tape that seals the attachment holes on the device).
ii.
Place the brackets on the device and tighten the mounting screws temporarily.
(4) Tighten screws to the specified torque.
Mount the device by tightening the screws to the specified torque. When the device is close to
perpendicular to the panel, make sure the brackets are in full contact with the device case while you
tighten the screw.
*Recommended screw torque: 10 to 12 kgf/cm
CAUTION
• Tightening screws to a torque exceeding 12 kgf/cm may cause damage to the case and/or brackets.
• Prevent any tools or objects from accidentally falling into the case through the attachment holes.
2-6
Masking tape
ii
i
Advertisement
Table of Contents
