Table of Contents
Advertisement
(1) Data capture bar
Indicates capture time and remaining capacity of the capturing media during data capture.
(When the remaining capacity runs short, the display turns orange.)
During replay, this bar shows information on the display position.
(2) Digital display
Displays the input value of each channel.
Values set for each channel can be checked by pressing the SPAN/TRACE/POSITION key.
For details on the SPAN/TRACE/POSITION key, see section 3-7.
(3) Pen display
Displays the position of each channel signal with icons.
Trigger position and alarm range are also displayed.
• Trigger level display
Displays the trigger level position and direction.
＜H＞
*Trigger level is also displayed when using horizontal scroll.
• Alarm range display
Displays the alarm position and range.
An alarm will be generated when a signal enters the green area shown in the figure below.
(When an alarm is generated, the display turns red.)
*Alarm range is also displayed when using horizontal scroll.
(4) Waveform display (Present)
Displays, in real time, the measurement signals as waveforms.
(5) Compressed waveform display (Past)
Displays compressed measurement signals.
The compression rate can be set in the menu.
For details on how to set the compression rate, see section 3-28.
(6) Sampling interval display
Displays the currently set sampling interval.
(7) File name display
Displays the name of the file currently captured
(displayed only during capture).
＜L＞
＜Win In＞
＜Win Out＞
Settings and Measurement
3-5
Advertisement
Table of Contents
