(7)-2 About the Macro
Interface commands for MT100 can be described in a text file and read in. MT100 will operate as
described in this file.
<Macro operation flow>
MT100 executes the commands
as described in the macro file.
Macro description example (file name: xxx.GMA)
CAUTION
Refer to the "Interface Command Table" for details on commands supported by MT100 on a separate sheet.
The "Interface Command Table" is included in the CD.
Supported commands are limited to those relative to MT100 settings.
Read in commands cannot be used.
Create a macro file using a text editor on your PC
(save the file with extension "GMA").
Copy this file to a USB memory, and then connect
the USB memory to MT100
Select the macro file and run the file.
・Macro file name:
・Execute Macro:
Settings and Measurement
3-37