Briggs & Stratton Legacy XL Operator's Manual page 41

Seat Adjustment
Seat Slide Adjustment
The seat can be adjusted forward and back. Move the lever
(A, Figure 53), position the seat as desired, and release the
lever to lock the seat into position.
Brake Adjustment
1. Disengage the PTO, stop the engine, block the wheels,
remove the ignition key, and engage the parking brake.
2. Remove the mower deck (see Mower Deck Removal).
3. Locate the brake spring (A, Figure 54). Measure the
length of the compressed brake spring with the parking
brake on. The compressed brake spring length should
be 3-1/2 to 3-3/4" (8,9-9,5cm).
4. If necessary, adjust the brake spring locknut to achieve
the correct compressed spring length. If this does not
correct a braking problem, see your dealer.
A
A
Figure 53
3.5-3.75"
(8.9-9.5cm)
Figure 54
Headlight Replacement
1. Open the hood.
2. Remove the forward heat shield.
3. Remove the light bulb socket (A, Figure 55) from the
bezel (B) by twisting it counterclockwise and pulling it
out.
4. Use a rag or gloves to remove and replace the light bulb
with an identical halogen bulb. DO NOT TOUCH THE
BULB WITH YOUR BARE HANDS.
5. Reinstall the socket into the bezel.
Taillight and Dash Light Replacement
1. Twist the socket counterclockwise and pull out to
remove it from the taillight or dashboard display as
shown in Figure 56.
2. Remove and replace the old bulb with a new identical
bulb.
3. Reinstall the socket into the taillight bezel or dashboard
display.
A
B
Figure 55
Figure 56
en
41