Briggs & Stratton Legacy XL Operator's Manual page 20

Raise and Lower the Roll Bar
WARNING
Avoid serious injury or death from roll over:
• Keep roll bar in the raised position and use seat belt.
• There is no roll over protection when the roll bar is
down.
• Lower the rollbar only when necessary and NEVER
remove it.
• Do NOT use seat belt when the roll bar is down.
• Raise the roll bar as soon as clearance permits.
• Do NOT jump off if mower tips.
To lower the roll bar:
1. Pull the hair pin clips (A, Figure 7) out of the retainer
pins (B).
2. Push or pull the top of the roll bar (C) forward against the
spring clips (D) and remove the retainer pins.
3. Lower the roll bar and reinstall the retainer pins and hair
pin clips to secure the roll bar in the down position (see
insert, Figure 7).
To raise the roll bar:
1. Pull the hair pin clips (A) out of the retainer pins (B) and
remove the retainer pins.
2. Raise the roll bar (C) until the top of the roll bar contacts
the spring clips (D) on the upright tubes.
3. Push or pull the top of the roll bar forward against the
spring clips and reinstall the retainer pins and hair pin
clips to secure the roll bar in the raised position.
B
A
20
D
C
Figure 7
Hydraulic System Function
General
All of the inboard and auxiliary hydraulics are controlled by
the attachment lift control lever. The attachment lift control
lever raises and lowers attachments that utilize the tractor's
hydraulic lift cylinder. This lever also controls attachments
that use the tractor's auxiliary hydraulics via the quick
couplers on the front left and right sides of the frame.
The rate of hydraulic fluid flow and pressure that are
available when using the auxiliary hydraulic quick couplers
is listed in the chart in Figure 8.
The lever has five positions: left, right, back, forward (first
detent) and float (pushed forward to second detent).
Implement Flow @ 3600RPM
7
6
A
5
4
3
0 100
A
= Implement Flow - gpm
B
= Pressure - psi
200 300 400
B
Figure 8