Briggs & Stratton Legacy XL Operator's Manual page 21

Using Inboard Hydraulics
The inboard hydraulics control the tractor's belly attachment
lift (mower deck) and three point hitch lift (if equipped). The
front / rear hydraulic selector switch must be in the REAR
position.
Pulling the lever back raises the attachment lift (A, Figure
9). Pushing the lever forward to the first detent lowers the
attachment lift (B). Pushing the lever forward to the second
detent locks the control in "float" position, allowing the lift
mechanism to float up and down.
A.
B.
Using Auxiliary Hydraulics
The attachment lift control is also used to control
attachments that use the tractor's auxiliary hydraulic
couplers located on the right and left front frame rails. The
left set of quick couplers is activated when the front / rear
hydraulic switch is turned to the FRONT position (this
disables the inboard hydraulic cylinder).
Moving the control lever to the left (A, Figure 10) angles the
attachment left. Moving the lever right (B, Figure 10) angles
the attachment right.
A.
B.
Figure 9
Figure 10
en
21