Briggs & Stratton Legacy XL Operator's Manual page 24

5. Attach the adjustable link assembly (M, Figure 17) and
lift link assembly (N) to sway arms (E) using clevis pins
(O) and hair pin clips (P).
6. Attach top of lower lift link assembly (M) to hitch using
clevis pin (N) and hair pin clip (O).
M
O P
E
540 Rear PTO Operation (Select Models)
Checks Before Starting
Refer to the Maintenance & Adjustments sections of this
manual and perform any needed service.
Connecting a Drive Shaft
1. Disengage the PTO, set the parking brake, stop the
engine, and wait for all moving parts to stop.
2. Pull back on the locking collar (A, Figure 18) and slide
the connector on the PTO shaft as far as it will go.
3. Pull back on the drive shaft until the locking collar snaps
into place. Check that the connection is secure.
A
24
Starting & Stopping the PTO
1. Stop the engine and remove the key. Set the parking
2. See Attachment Operator's Manual or Installation
3. Start the tractor engine. Allow the engine to warm-up for
4. Set engine throttle to FULL.
5. Place the PTO selector lever in the rear position (A,
P N
O
P
E
Figure 17
6. Pull UP on the PTO switch to engage the PTO.
7. When finished, move the throttle control to IDLE and
8. When disconnecting the attachment, stop the engine,
Engine Speed Selection
When engaging the rear PTO, set the throttle to FULL.
When disengaging the rear PTO, set the throttle to IDLE
and allow the attachment to slow down. While using an
attachment, always set the throttle to FULL.
Figure 18
brake.
to properly install/connect the attachment
Instructions
to be used. If connecting to a stationary attachment, set
the parking brake during attachment operation.
several minutes before engaging the PTO.
Figure 19) if only a rear attachment is being used. If a
mid and rear attachment are being used simultaneously,
place the lever in the mid position (B). If only a mid or
front attachment is being used, place the control in
position (C).
A.
B.
push the PTO switch DOWN to disengage. Wait for all
moving parts to stop.
remove the key, and set the parking brake. Wait for all
moving parts to stop.
C.
Figure 19