Briggs & Stratton Legacy XL Operator's Manual page 14

Steering Tilt Adjust (Select Models)
Use the tilt knob located on the bellows to
release the pivot mechanism and pivot the wheel
to the desired position. Release the tilt knob to
lock in position.
Seat Adjustment Lever
The seat can be adjusted forward and back.
Move the lever, position the seat as desired, and
release the lever to lock the seat into position.
Cruise Control
The cruise control is used to lock the ground
speed control in forward. Move the lever forward
until the desired ground speed is reached. To
disengage the cruise control move the lever back.
In the event you need to stop quickly, depressing
the brake pedal will also return the cruise control
to neutral.
Headlights
The light switch turns the tractor headlights on
and off.
2-Wheel / 4-Wheel Drive Selector
2WD
(Select Models)
4WD The 2-wheel / 4-wheel drive selector disengages
the front wheels in the 2-wheel drive position and
drives all four wheels in 4-wheel drive position.
Engage / disengage the 4-wheel drive control
only when stopped or at slow speeds.
Transmission Release Valve Lever
The transmission release valve lever deactivates
the transmission so that the tractor can be
pushed by hand. See PUSHING THE TRACTOR
BY HAND for operational information.
Fuel Tank
To remove the cap, turn counterclockwise.
Transmission Oil Level Check Plug
Transmission oil check plug/dipstick is used
to check transmission oil level and to add oil
to the transmission. See TRANSMISSION
MAINTENANCE for oil level check
and fill procedures.
14
Power Outlet (Select Models)
12V
The power outlet is 12V-DC. Accessory must be
rated at 14 amps or less.
Mid / Rear PTO Selector
The mid / rear PTO selector lever selects which
PTO or combination of PTOs is activated by the
PTO switch. The selector has three positions
(from front to back:) mid PTO active only, mid and
rear PTO active, rear PTO active only. Disengage
the PTO switch before altering this control's
setting.
Front / Rear Hydraulics Selector
The front / rear hydraulics selector switches
which hydraulic circuit is controlled by the forward
and backward movement of the attachment lift
lever.
When the switch is in the forward position, the
attachment lift control lever affects attachments
connected to the two front left quick couplers.
When the switch is in the rear position the
attachment.
Differential Lock Pedal
Depressing this pedal locks the transmission
differential, locking both rear wheels into "drive".
Use this feature if the tractor is stuck because
one wheel is slipping. Engage the differential
lock at slow ground speeds only.
Choke (Select Models)
Close the choke for cold starting. Open the choke
once the engine starts. A warm engine may not
require choking. Pull the choke control out to
close the choke.
PTO Switch
The PTO (Power Take-Off) switch, in conjunction
with the mid / rear PTO selector, engages and
disengages attachments connected to the
tractor's mid or rear PTO shafts. To engage the
PTO, pull UP on the switch. Push DOWN to
disengage. Be sure to check the position of the
mid / rear PTO selector lever before engaging
the PTO. DO NOT engage a PTO that is not
connected to an attachment as the rotating shaft
is a safety hazard.
Note: The operator must be seated firmly in the
tractor seat for the PTO to function.