Briggs & Stratton Legacy XL Operator's Manual page 35

Lubrication
Lubricate the unit at the locations shown in Figures 37-43
as well as the lubrication points listed. Generally, all moving
metal parts should be oiled where contact is made with
other parts. Keep oil and grease off belts and pulleys. Wipe
surfaces clean before and after lubrication.
Grease:
• steering linkage
• foot pedal
• mower linkage
• transmission idler assembly pivot
• rear axle shafts (remove wheel hubs)
• front axle where it contacts the frame
• all drive shaft universal joints
• mower belt tension bracket pivots
Use grease fittings when present. Automotive lithium
grease is recommended.
Oil:
• control linkage
• seat adjustment assembly
• brake linkage
• mower deck height adjustment linkage
• manual lift lever
FRONT
Figure 376
Figure 38
Figure 39
Figure 40
en
35