Briggs & Stratton Legacy XL Operator's Manual page 15

Dashboard Display Functions
The dashboard display shows a variety of engine operation
and control status information, as explained in the
descriptions below.
A. Irregular Voltage (Liquid Cooled Models)
Indicates that the voltage being produced by the charging
system and battery is higher or lower than normal levels.
B. Rear PTO Light
Indicates that the optional rear PTO is engaged.
C. Mid (Front) PTO Light
Indicates that the mid PTO is engaged.
D. Hour Meter/Clock
Displays number of hours the unit has been operated.
E. Cruise Control Light
Indicates that the cruise control is engaged.
F. Low Oil Pressure Light
Indicates that the engine oil pressure is low. If this indicator
lights, shut the engine off immediately and contact your
dealer.
G. 4 Wheel Drive Light (4WD Models Only)
Indicates that 4 wheel drive is engaged.
H. Fuel Separator Full Light (Diesel Models)
Indicates that the fuel separator is full and must be emptied.
I. Fuel Gauge
The fuel gauge shows the level of fuel in the fuel tank.
J. Tachometer
Displays the engine RPM. Normal operating speed is 3400
RPM. Do not operate at less than 3000 RPM during normal
use.
K. Coolant Temperature (Liquid Cooled Models)
Shows the engine coolant temperature.
L. Glow Plug Light (Diesel Models)
Indicates that the glow plugs are heating. Leave the key in
the run position until the light goes out, then turn the key to
start.
M. Voltmeter (Models with Air-Cooled Engines)
Shows the voltage being produced by the charging circuit
and battery.
Models with Liquid Cooled Engines
See Figure 3.
Models with Air Cooled Engines
A B C
L K
B C
M
D E F G
J I H
D E F G
J I
Figure 3
en
15