Table of Contents
Advertisement
Position 10
Last alarm display and
possible reset
6 ALARMS ENV06 dryers
6.1 Displaying the alarms to the user
Operation of the alarms is configurable according to the model. Some or all of the alarms may be displayed
to the user.
When an alarm condition occurs, the drying cycle may be interrupted or paused; in some cases, for the
sake of safety, a forced cooling cycle is performed. In this case, the electronic board, if possible,
disconnects the power relay from the heater unit and powers the motor of the drum cooling fan. The cycle
remains active until the user switches off the appliance.
6.2 Alarm display during normal operation
On models with LCD the system displays the family of the
current alarm to the user.
If for example we consider E53 alarm (problems with the
motor TRIAC) the display will show as follows:
•
First digit: letter "E" (error)
•
Second-third digit: the no. "5 0", i.e. the family of alarm
E53)
The same number is displayed by a repeated flashing sequence of START LED of RED colour with a cycle
(0,4 seconds on, 0,4 seconds off with a 2,5 second pause between the sequences); in case of E53, the
series of five flashes indicates the first of the two E
are grouped in families).
6.3 Reading the alarm codes
To read the last alarm code memorized in the EEPROM of the electronic board:
Access diagnostics mode (see paragraph).
Turn the programme selector knob clockwise to see the last alarm (for more information see the
diagnostic section), paying attention not to stop in other positions, because error 32 could occur).
6.4 Displaying the alarm code on models with LCD
•
First digit: letter "E"
•
Second digit: the family of the alarm
•
Third digit: the alarm number
6.5 Displaying the alarm code in all models without LCD
The alarm code is displayed by a repeated sequence of flashing of the LED START (0.4 seconds on,
0.4 seconds off, with a pause of 2.5 seconds between sequences). The buzzer emits a series of "beeps"
in synchronization with the flashing of the LED.
START LED with RED light: indicates the first digit of the alarm code (family)
START LED with GREEN light: indicates the second digit of the alarm code (number inside the family).
SOI/ADL 2009-10
Purpose of test:
Behaviour:
Working conditions:
To see the allarm and reset it
The LCD displays the alarm while the LED will flash
on the basis of alarm
Turn the knob till position 10, paying
attention not to stop to position 7, otherwise
error 32 may occur
5
3 alarm digits (the alarms relative to the same function
28/63
599 72 40-73
Advertisement
Table of Contents
