Table of Contents
Advertisement
4 DIAGNOSTICS on ENV06 / ENV06 AEG CLOTHES REFRESHMENT
4.1 Acess to diagnostics
1. Press the defined combination key
(START + the nearest key on the left) and keeping them pressed
2. Switch on the machine rotating the main selector in the 1st position CW..
3. Within 5 second phases led blinks and buzzer sounds to give acknowledge of the operation.
ENV06
4.2 Exiting the diagnostics system
To exit from DIAGNOSTIC mode it's sufficient to switch off the machine.
According to the machine configuration, it's possible that the next machine switch on, the electric test cycle
will be activated. To stop it, switch off again the machine.
Moving the main knob in clockwise direction, the following tests will be done:
Position 1
User Interface Test
Position 2
Condense tank switch
and pump + steamer
tank Switch, heater
and NTC
SOI/ADL 2009-10
Purpose of test:
Activated components:
Behaviour
Working conditions:
Purpose of test:
Activated components:
ENV06 AEG
To test the functionality of all leds and switches
All LEDs and LCD
All led in sequence, pushing a button correspondent led
is lighted on, the key number is showed on LCD and the
buzzer sound.
All LCD icons blink together.
There is any control to run test (always active)
To test the condense tank pump and switch.
To test the steamer tank switch, heater and NTC
If the pump is full of water and the tank switch recognises
the condition, the pump is switched on.
Steamer starts heating up procedure activating heater.
Once the temperature reaches heating up setting (135
it is controlled between working limits (130
22/63
ENV06 Catalogue
/ action
º
º -
º
150
).
599 72 40-73
),
Advertisement
Table of Contents
