Detector Testing - AJAX MotionProtect User Manual

Unpair device
Before using the detector as a part of the security system, set up the suitable
sensitivity level.
Switch the Always Active if the detector is located in a room requiring 24-hour
control. Regardless of whether the system is set in the armed mode, you will
receive notices of any detected motion.
If any motion is detected, the detector activates the LED for 1 second and
transmits an alarm signal to the hub and then to the user and central monitoring
station (if it is connected).
Detector operation indication
Event
Turning on the detector
Detector connection to the
hub ocBridge Plus
,
uartBridge
Alarm / tamper activation
Battery needs replacing

Detector Testing

The Ajax security system allows conducting tests for checking the functionality
of connected devices.
The tests do not start immediately but within a period of 36 seconds when using
the standard settings. The time of the start depends on the settings of the
detector polling period (the paragraph on Jeweller settings in the hub settings).
Indication
Lights up green for about one
second
Lights up continuously for a
and
few seconds
Lights up green for about one
second
During the alarm,slowly lights
up and goes off green
Disconnects the detector from the hub and
deletes its settings
Alarm is sent once in 5
seconds
Replacement of the detector
battery is described in the
Battery Replacement
manual
Note