Unusual Behavior Of The Dishwasher - Miele PG 8056 Operating Instructions Manual

Unusual behavior of the dishwasher

Problem
Program finished has
appeared on the display
and you cannot select or
start a program.
The dishwasher fails to
react when buttons are
pressed. The display and
indicator lights remain
dark.
The following fault
message is appears in the
display:
Salt container lid not closed
correctly
The dispenser cover
cannot be closed.
Water remains in the wash
cabinet at the end of a
program.
Peak load cut-out
Possible cause and solution
This is not a fault.
Open and close the door.

The dishwasher must remain switched on while you do
this.
The dishwasher has turned itself off after the set Switch-off
time to save energy.
Press the  button to turn the dishwasher on again.

The salt reservoir cover is not properly closed.
Close the salt reservoir cover.

Detergent residue is blocking the latch.
Remove the detergent residue.

Before remedying the fault:
Switch the dishwasher off with the  button.

The filter combination in the wash cabinet is clogged.
Clean the filter combination (see "Cleaning and care").

The drain pump or non-return valve is blocked.
Clean the drain pump or the non-return valve (see

"Frequently asked questions").
The drain hose is kinked.
Remove the kink.

The on-site drain trap is clogged.
Check and clean the drain trap.

This is not a fault!
Your energy management system has detected a peak-
load in the energy supply. Some components in the
dishwasher stop operating for the duration of the peak-
load cut-out.
Frequently asked questions
103