Pir (Motion Sensor) - LG MultiSITE CRC1 Series User Interface Manual

CONFIGURATION SCREENS

PIR (Motion Sensor)

The MultiSITE CRC1+ version of the controller comes with an onboard PIR style motion sensor. If the sensor is
enabled (installer configuration under Accessories), status from the PIR sensor will be used to control the opera-
tion of the IDU as follows:
If the IDU status is currently Occupied and the onboard PIR goes Unoccupied, the IDU will operate according to
the Setback values of the controller and will change its status to Unoccupied.
If the IDU status is currently Unoccupied and the onboard PIR goes Occupied, the IDU will operate according to
the settings in use during the last Occupied status and will change its status to Occupied.
If the IDU is currently in Setback or Override modes, information from the PIR sensor will be ignored.
Due to our policy of continuous product innovation, some specifications may change without notification.
52
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.