Configuration Main Screens - LG MultiSITE CRC1 Series User Interface Manual

CONFIGURATION SCREENS

Configuration Main Screens

There are two main configuration screens as shown below. Press the left and right arrow buttons to move
between these two screens. Press a button on a screen to display the parameter selections for that item.
Configuration 1/2
Building Manager
Installer
BMS Config
Basic Diagnostic
Password Setup
Factory Default
Configuration 2/2
Wireless Ecosystem
18
Enter Display, Date & Time, Filter, Setpoints, Override,
Setback and Outdoor Unit configuration
Enter General, Temperature, Fan and Heat settings and
Accessories configuration
Enter BACnet settings
View Diagnostic parameters
Setup a password to restrict/allow access to the thermostat
Reverts all controller control settings back to default values.
Note: Users will be given the option to confirm that they wish to
proceed. Once in the Factory Default screen, if user proceeds
with this step, all schedules and current controller settings includ-
ing time and date will be cleared. Settings cannot be recovered
after a Factory Default has been performed.
Enter ZigBee wireless zone configuration settings.
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.