Date Menu; Update Menu - visual engineering H.264 User Manual

Visual Engineering
HD IP Camera

Date Menu

The date menu page allows the user
to synchronise the camera time to
a SNTP server. In this instance it is
necessary to have the PC connected
to a network.
If a network connection is not
available it is possible to synchronise
the camera to the PC time by ticking
the "Sync Camera to PC Time" check
box and pressing the submit button.
The "UTC Offset" can be altered to
align the camera time with the local
time zone. To align the camera to the
actual PC time the "UTC Offset" should
be made same as the value displayed
in the "PC UTC Offset" field.

Update Menu

It is possible to update the
firmware of the HD IP camera.
There are three steps to updating
the camera firmware, as shown on
the right.
Only update the camera
with files that have
been approved by Visual
Engineering.
Use of other files will render
the camera inoperable.
Following a Submit the camera will update the firmware and display the following text:
Programming in Progress...Do not remove power
Wait until the web page clears this text before trying to move away from the current web page or
powering off the camera. Updates typically take approx 3 minutes to complete.
Important: To fully ensure the upgrade has finished it is advised to refresh the web page
and check the banner displays
video before switching off the power.
It is advised that following a firmware update that the Restore Defaults button is pressed, this
will revert the camera back to a default start state. The IP address of the camera will revert to its
default IP address of 192.168.1.195 following a power cycle.
Pressing the Reset button will completely re-start the camera.
visualengineering.co.uk
Video solutions. Integrated
"HD IP Camera
submit to sync the camera
1. Select the
Update tab
v4.00" or the camera starts to once again stream
Tick this box and press
to the PC time
3. Submit
the file
2. Browse to
the file
August 2020
Page 13