Date Menu; Update Menu - visual engineering TMC 3 User Manual

Visual Engineering
TMC 3

Date Menu

The date menu page allows the user
to synchronise the camera time to
an SNTP server. In this instance it is
necessary to have the PC connected
to a network.
If a network connection is not
available it is possible to synchronise
the camera to the PC time by ticking
the "Sync Camera to PC Time" check
box and pressing the submit button.
The "UTC Offset" can be altered to
align the camera time with the local
time zone. Changes are only enabled
when the submit button is pressed.
To align the camera to the actual PC
time the "UTC Offset" should be made
same as the value displayed in the "PC
UTC Offset" field.

Update Menu

It is possible to update the camera
encoder firmware of the TMC 3.
There are three steps to updating
the firmware, as shown on the
right.
Only update the camera
with files that have
been approved by Visual
Engineering.
Use of other files will render
the camera inoperable.
Following a Submit the camera will update the firmware and display the following text:
Programming in Progress...Do NOT remove power
Wait until the web page clears this text before trying to move away from the current web page or
powering off the camera. Updates typically take approx 3 minutes to complete.
Important: To fully ensure the upgrade has finished it is advised to refresh the web page
and check the banner displays
video before switching off the power.
It is advised that following a firmware update that the Restore Defaults button is pressed, this
will revert the encoder back to a default start state. The IP address of the encoder will revert to
its default IP address of 192.168.1.195 following a power cycle.
visualengineering.co.uk
Video solutions. Integrated
"IP Encoder
1. Select the
Update tab
v3.22" or the camera starts to once again stream
September 2017
Tick this box and press
submit to sync the camera to
the PC time
3. Submit the file
2. Browse to the file
Page 16