Date Menu; Update Menu - visual engineering SWZ HD User Manual

Visual Engineering
SWZ HD

Date Menu

The date menu page allows the user
to synchronise the camera time to
an SNTP server. In this instance it is
necessary to have the PC connected
to a network.
If a network connection is not
available it is possible to synchronise
the camera to the PC time by ticking
the "Sync Camera to PC Time" check
box and pressing the submit button.
The "UTC Offset" can be altered to
align the camera time with the local
time zone. Changes are only enabled
when the submit button is pressed.
To align the camera to the actual PC
time the "UTC Offset" should be made
same as the value displayed in the "PC
UTC Offset" field.

Update Menu

It is possible to update the
firmware of the SWZ HD camera.
There are three steps to updating
the camera firmware, as shown on
the right.
Only update the camera
with files that have
been approved by Visual
Engineering.
Use of other files will render
the camera inoperable.
Following a Submit the camera will update the firmware and display the following text:
Programming in Progress...Do NOT remove power
Wait until the web page clears this text before trying to move away from the current web page or
powering off the camera. Updates typically take approx 90 seconds to complete.
If the camera currently has a version of firmware that is v2.3 or earlier it is advised to leave the
camera for an extended time before turning off the power. To fully ensure the upgrade has
finished it is advised to check that the web interface can be navigated or the camera starts to
once again stream video before switching off the power.
It is also advised that following a firmware update that the Restore Defaults button is pressed. This
will revert the camera back to a default start state.
visualengineering.co.uk
Video solutions. Integrated
Tick this box and press
submit to sync the camera
to the PC time
3. Submit the file
1. Select the 2. Browse to the file
Update tab
September 2017
Page 9