Setting Up The Carriage; Checking The Workpiece Surface And Carriage; Placing The Carriage - Fronius ArcRover 22 Translation Of Original Operating Instructions

Setting up the carriage

Checking the Before positioning the carriage, check the following:
workpiece sur- -
face and carriage -
-
-
Placing
the carriage
The surface of the workpiece must be clean (no sand, shavings, etc.)
The base plate of the carriage must be free of objects which can be attracted by the
magnet
The rubber elements of the drive wheels must be undamaged and free of swarf
The guide wheels must be clean, undamaged and free of welding spatter
WARNING!
The activated permanent magnet poses a risk of injury.
There is a danger of injury to the fingers when positioning the carriage.
- Only hold the carriage by the handle and not by the base plate.
1. Place the carriage on the workpiece.
The side guide wheels must be in
contact with the workpiece.
2. If necessary, correct the position of the
guide wheels.
NOTE!
Detailed informations on „Setting up
the guide rails" can be found in chapter
„Preparing the carriage".
3. Set the permanent magnet control
lever to the "ON" position.
39