Mounting, Connecting, Dismounting; Mounting; Connecting; Dismounting - IBA MS8xICP Manual

ibaMS8xICP
6

Mounting, Connecting, Dismounting

Works on the device must NOT be done when it is under voltage! Always disconnect
the central unit from the power supply!
Note
Mount one or more modules on the right next to the central unit (slot X2 to X5 can be
freely selected).
6.1

Mounting

1. Disconnect the central unit from the power supply.
2. Remove the cover from the backplane bus, to which the module should be attached.
3. Attach the device to the backplane bus and press it firmly against the backplane.
4. Secure the device with the fixing screws.
Important Note
Always screw tight the device and the modules. If you do not screw it tight, connecting or
disconnecting the connectors for the inputs and outputs might cause damages.
6.2

Connecting

Note
The backplane unit and the device must be connected to a protective conductor.
1. Connect all cables.
2. If all required cables are connected, connect the central unit to the power supply.
3. Switch on the central unit.
6.3

Dismounting

1. Disconnect the central unit from the power supply.
2. Remove all cables.
3. Remove the both fixing screws on the upper and the lower side of the device.
4. Pull the device straight from the backplane.
5. Put the cover on the backplane bus.
Manual
Issue 1.7
11