Set Up The Shaking Platform - Thermo Scientific Shake n Stack 6240 Operating And Maintenance Manual

Thermo Scientific

Set Up the Shaking Platform

Section 3
Slot
Drive shaft
screw
Location
peg
Rotisserie drive shaft
Drive arm
Shaker peg
Shaker tray
Figure 1. Shaking Tray Components
1. The shaker bracket is installed at the
factory. If replacement should ever
become necessary, instructions follow.
Continue to Step 2.
• Loosen existing screws at the bottom
of the oven back sufficiently to allow
slots in bracket to slide down onto
screw shafts. Retighten screws to
secure back plate. See Figure 2.
2. Fit the rear right hand peg of tray into
vertical slot at right of bracket,
allowing tray to temporarily rest on
oven base. Refer to Figure 3.
Drive Arm
Assembly Sleeve
Thumb
Fan
screw
Screw
Figure 2. Replace Shaker Bracket
Figure 3. Insert Tray Peg into Slot
Oven back
Bracket
Shaker peg
Oven base
Shake 'n Stack 3-1