All Channel Search Mode; Direct Number Access Mode; Category Search Mode; Preset Search Mode - Yamaha RX-V361 Owner's Manual

y
When performing these operations with the remote control, press
C XM to select "XM" as the input source.

■ All Channel Search mode

Press 2 SEARCH MODE (or P SRCH
1
MODE) repeatedly to select "ALL CH
SEARCH".
Press 5 PRESET/TUNING/CH l / h (or
2
G PRESET/CH k / n) repeatedly to search
for a channel within all channels.
y
• You can search for a channel quickly by pressing and holding
5 PRESET/TUNING/CH l / h (or G PRESET/CH k / n).
• To display the XM Radio ID number displayed in the front
panel display, select channel "0".

■ Category Search mode

Press 2 SEARCH MODE (or P SRCH
1
MODE) repeatedly to select "CAT SEARCH".
Press 4 CATEGORY (or G A-E/CAT. l / h)
2
repeatedly to change the channel category.
Press 5 PRESET/TUNING/CH l / h (or
3
G PRESET/CH k / n) repeatedly to search
for a channel within the selected channel
category.
y
You can search for a channel quickly by pressing and holding
5 PRESET/TUNING/CH l / h (or G PRESET/CH k / n).

■ Preset Search mode

Prior to selecting a preset channel in the Preset Search
mode, you must preset XM Satellite Radio channels. For
details, see "Setting XM Satellite Radio preset channels"
on page 40.
y
All preset channels (A1 to E8) recalls "001 Preview" by the initial
factory setting.
Press 2 SEARCH MODE (or P SRCH
1
MODE) repeatedly to select "PRESET
SEARCH".
Press 4 CATEGORY (or G A-E/CAT. l / h)
2
repeatedly to change the preset channel
group (A to E).
Press 5 PRESET/TUNING/CH l / h (or
3
G PRESET/CH k / n) repeatedly to change
the preset channel number (1 to 8).
y
You can also select the preset channel number directly by
pressing the numeric buttons (1 to 8) on the remote control.

■ Direct Number Access mode

Press P SRCH MODE repeatedly to select
1
"ALL CH SEARCH" or "CAT SEARCH".
2
Press the numeric buttons (V) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons as shown below.
l
1
The display changes as follows.
<XM> --1
<XM> -12
<XM>123
y
• To enter a one-digit or two-digit channel number, press the
numeric buttons (V) and then press W ENT. to confirm the
input number. Instead of pressing W ENT. to tune into the
channel immediately, you can wait a few seconds until this unit
confirms the entered channel number.
• If no button is pressed within a few seconds after you enter a
one-digit or two-digit number, this unit automatically confirms
the entered channel number.
• Pressing a button other than the numeric buttons (V) or
W ENT. cancels the Direct Number Access mode procedure.
XM Satellite Radio tuning
h
ENHANCER
2 3
39
En