Table of Contents
Advertisement
■Near detection area
●Detecting near area
When detection of nearer area is required, remove "Area masking
plate" stored inside so that the right-and-left auxiliary detection zone
can function.
Check the direction of auxiliary detection zone and the detecting
performance for proper operation.
Remove all "Area masking plate" stored in 3 x reflection mirror inside
the sensor unit.
* Avoid soiling the mirror surfaces with dirt or fingerprint.
To disable the auxiliary zone after removing "Area masking
plate (x3)", replace them in the original positions.
In that case, remove the adhesive, and replace "Area masking
plate" in the positions of "F", "R" and "C", as indicated on the
adjacent diagram.
Each of the 3 "Area masking plates" are uniquely shaped so
make sure to replace them correctly before operation.
●Detecting area directly beneath the sensor
When detecting area directly under the sensor, select "ON" in DIP
switch 8 (Creep zone detection setting) in Mode selector 1.
Please note that the pet immunity performance decreases when this
setting is enabled.
This setting is disabled in the high density mode.
(Refer to "7. FUNCTION")
■Masking method of the detection area
●Detection area setting to less than 66'(20m)
When the detection area is adjusted to less than 66'(20m), set area selector
position and mask the detection area using the supplied area masking sheet, and set "ON" in
the short distance setting (dip switch 5 in mode selector 2).
(Refer to "7. FUNCTION", "8. ADJUSTMENT OF DETECTION AREA")
When masking each detection area from ① to ④, attach the area
masking sheet
to
the surface of the mirror unit corresponding to
the detection area as indicated with the arrow
* Avoid soiling the mirror surfaces with dirt or fingerprint.
【Top view】
【Side view】
Installation
height
(3.0m)
■Precautions on the detection area setting
●Detection area range
Since the detection zone extends until it hits the ground or
wall surface, the unit may detect objects even in places
beyond the specified distance. In order to avoid unexpected
detection, adjust the area sufficiently.
④
④
③
②
26
33
40
53
(8m)
(10m)
(12m)
(16m)
【Top view】
to
"66'(20m)"
③
①
④
②
①②③
①
Area masking sheet
Attach the area masking sheet in order (①→④) from
the longest part of the detection area,
detection distance.
●Detection area distance adjustment
When the detection area is adjusted to less than 66'(20m), please
mask the detection area using the supplied area masking sheet.
(Refer to "8 ADJUSTMENT OF DETECTION AREA")
* Attach the area masking sheet in order from the longest part of
the detection area, and adjust the detection distance.
④
Auxiliary detection zone
C
F
R
and
Aea masking
plate
Adhesive
③
①
④
②
adjust the
Advertisement
Table of Contents
